Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!cbosgd!ihnp4!houxm!whuxl!whuxlm!akgua!gatech!ut-sally!topaz!caip!AFA-DFSEC
From: AFA-DFSEC@caip.UUCP
Newsgroups: net.micro.amiga
Subject: Problem with Amigaterm.c and Lattice 3.03
Message-ID: <1055@caip.RUTGERS.EDU>
Date: Tue, 21-Jan-86 19:15:27 EST
Article-I.D.: caip.1055
Posted: Tue Jan 21 19:15:27 1986
Date-Received: Thu, 23-Jan-86 21:56:46 EST
Sender: daemon@caip.RUTGERS.EDU
Organization: Rutgers Univ., New Brunswick, N.J.
Lines: 17

From: AFA-DFSEC@GUNTER-ADAM.ARPA

I was recently trying to implement kermit protocals into Michael Mounier's
Amigaterm.  I compiled it with 3.03 and got no error messages but when the
program fired up I got a CLI TASK HELD error and then a guru meditation number.

I checked through the code, even tried recompiling the original with the same
results.  I have narrowed it down to the Serial Port stuff but am stuck there.

If I take out the OPen serial all works fine, or if I take out the SetMenuStrip
all works fine.  Any ideas would be nice.  If I get this problem overcome I
gladly post Amigaterm with Kermit protocals.

By the way, Aterm does compile under 3.02 but my kermit code does not. It gets
a CZXERR in pass 2.  HWELP!!
Glenn Watt
-------