Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2 9/13/84; site intelca.UUCP
Path: utzoo!watmath!clyde!burl!ulysses!bellcore!decvax!decwrl!sun!idi!intelca!cem
From: cem@intelca.UUCP (Chuck McManis)
Newsgroups: net.micro.amiga
Subject: Re: Problem with Amigaterm.c and Lattice 3.03
Message-ID: <192@intelca.UUCP>
Date: Wed, 22-Jan-86 15:58:45 EST
Article-I.D.: intelca.192
Posted: Wed Jan 22 15:58:45 1986
Date-Received: Fri, 24-Jan-86 21:34:15 EST
References: <1055@caip.RUTGERS.EDU>
Organization: Intel, Santa Clara, Ca.
Lines: 28

I have the same problem, any hints from Amiga or Lattice on what they 
may have changed in the SetMenuStrip call between V3.02 and V3.03?

--Chuck

> From: AFA-DFSEC@GUNTER-ADAM.ARPA
> 
> I was recently trying to implement kermit protocals into Michael Mounier's
> Amigaterm.  I compiled it with 3.03 and got no error messages but when the
> program fired up I got a CLI TASK HELD error and then a guru meditation number.
> 
> I checked through the code, even tried recompiling the original with the same
> results.  I have narrowed it down to the Serial Port stuff but am stuck there.
> 
> If I take out the OPen serial all works fine, or if I take out the SetMenuStrip
> all works fine.  Any ideas would be nice.  If I get this problem overcome I
> gladly post Amigaterm with Kermit protocals.
> 
> By the way, Aterm does compile under 3.02 but my kermit code does not. It gets
> a CXERR in pass 2.  HWELP!!
> Glenn Watt
> -------

-- 
                                            - - - D I S C L A I M E R - - - 
{ihnp4,fortune}!dual\                     All opinions expressed herein are my
        {qantel,idi}-> !intelca!cem       own and not those of my employer, my
 {ucbvax,hao}!hplabs/                     friends, or my avocado plant. :-}