Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Posting-Version: version B 2.10.2 9/5/84; site bunker.UUCP Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxt!houxm!ihnp4!cbosgd!ukma!psuvm.bitnet!psuvax1!burdvax!sdcrdcf!sdcsvax!ucbvax!decvax!ittatc!bunker!wtm From: wtm@bunker.UUCP (Bill McGarry) Newsgroups: net.rec.wood Subject: Re: Repair of Sears Table Saws Message-ID: <1085@bunker.UUCP> Date: Tue, 14-Jan-86 23:23:42 EST Article-I.D.: bunker.1085 Posted: Tue Jan 14 23:23:42 1986 Date-Received: Sun, 19-Jan-86 05:44:15 EST Reply-To: wtm@bunker.UUCP (Bill McGarry) Organization: Bunker Ramo, Trumbull Ct Lines: 27 > Why on earth would have a repair man come out to look at your saw to replace > motor, when almost every Sears store has the motor in stock? The cost is > about $110. You just have to unbolt the old one and take off the pulley. > The instructions on how to do this came with the saw. Yes, every Sears store stocks the replacement motor but replacing the motor on this particular model is an unbelievable bitch. To get the motor out, you have to virtually disassemble the entire saw. It is NOT just a matter of taking a few bolts out and popping in a new motor. The repair man that came to the house could not even do it - and believe me - he tried. He had to take it back with him. The big problem is one big pin (10 inches long or so) that holds the motor. There is no easy access to this pin and so no easy way to get the motor out. The instructions that came with the saw? They give you an exploded diagram of the entire saw on one page - no help at all ( And I used to repair power tools for a couple of years.) Poor design but I think the saw is still worth the money. Sears charged about $20 (if I remember right) for the labor and this included taking the motor out, putting the new one in and adjusting it just right. For this, it wasn't worth the effort to do it myself. Bill McGarry Bunker Ramo, Trumbull, CT bunker!wtm