Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!cbosgd!ihnp4!houxm!whuxl!whuxlm!akgua!gatech!seismo!brl-tgr!tgr!RCONN@SIMTEL20.ARPA
From: RCONN@SIMTEL20.ARPA
Newsgroups: net.micro.cpm
Subject: Re: ZCPR for RS Model 4
Message-ID: <2035@brl-tgr.ARPA>
Date: Tue, 28-Jan-86 02:48:04 EST
Article-I.D.: brl-tgr.2035
Posted: Tue Jan 28 02:48:04 1986
Date-Received: Thu, 30-Jan-86 05:34:15 EST
Sender: news@brl-tgr.ARPA
Lines: 17

If you cannot modify your BIOS, Z3-DOT-COM is about your only option.
This is a commercial product from Echelon, and it takes only a few
minutes to install.  It creates a COM file that contains a Z-System.
On cold boot, run the COM file and it installs a Z-System in memory.

This option lacks the full functionality of the Z-System, and users
(in my experience) often want to later create a manually-installed Z-System
to pick up on the lack of functionality.  However, it is an easy out,
does not require a BIOS modification, and is a minimum of hastle (very small
learning curve and very little installation overhead).

There is a possibility that an RS Model 4 installation of ZCPR3 is
available, but I don't really know.  Echelon is the source to contact for
installation-specific questions.

	Rick
-------