Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!linus!decvax!decwrl!pyramid!ut-sally!topaz!caip!daemon
From: haddock%ti-csl.csnet@CSNET-RELAY.ARPA@caip.RUTGERS.EDU
Newsgroups: net.micro.amiga
Subject: Re:  Opening com port... (Reply to Jim Reich)
Message-ID: <1277@caip.RUTGERS.EDU>
Date: Sat, 15-Feb-86 13:25:37 EST
Article-I.D.: caip.1277
Posted: Sat Feb 15 13:25:37 1986
Date-Received: Sun, 16-Feb-86 09:02:50 EST
Sender: daemon@caip.RUTGERS.EDU
Organization: Rutgers Univ., New Brunswick, N.J.
Lines: 15

From: Rusty Haddock <haddock%ti-csl.csnet@CSNET-RELAY.ARPA>


Jim,
    I don't know what's causing your problems with MaxiComm but
I'm using a *REAL* :-) Hayes 1200 connected to my Amiba with
absolutely no problems (except those 'cause by the imitation
programmers at MaxiCorpse).   Make sure that you've cut the
lines in the serial connector that are carrying power and audio.
There was an article about this a while back and I don't have my
Amiga manuals handy.   Though, do check the back of your
_Introduction_the_Amiga_ manual which you got with your machine
if you're familiar with RS-232.

				-Rusty-