Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!burl!ulysses!bellcore!decvax!genrad!panda!talcott!harvard!seismo!brl-adm!brl-smoke!smoke!shawn@ACC.ARPA
From: shawn@ACC.ARPA
Newsgroups: net.micro.cpm
Subject: re:M-100/KAYPRO connection
Message-ID: <1270@brl-smoke.ARPA>
Date: Tue, 25-Feb-86 19:17:39 EST
Article-I.D.: brl-smok.1270
Posted: Tue Feb 25 19:17:39 1986
Date-Received: Sat, 1-Mar-86 23:31:53 EST
Sender: news@brl-smoke.ARPA
Lines: 17


to: finholtAc.cs.cmu.edu(couldn't send to you so am posting)
re: m-100/KAYPRO hookup
There is a program called TERM that you should be able to use
if you set the console up (CON:) to be the serial port (using CONFIG)
also use CONFIG to set up the required baud-rate if different than
"normal" (whatever that is). You should then be able to "run" the
KAYPRO from the serial port. I don't know if this will allow binary
transfers but should be OK for ASCII. There is also a users group
for the M-100 users. The moderator is -drew- and the address is on
the ARPA net (as well as some others) info-laptops-request@mit-oz
the net itself is the same less -request. They have message and
program archives, and seem very knowledgable. I hope this gets
you what you need. I don't know why I couldn't get to your address
but then I'm NOT a 'net person'. 	shawn@acc.arpa

------