Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxn!mhuxm!mhuxf!mhuxi!mhuhk!mhuxt!houxm!whuxl!whuxlm!akgua!gatech!cbosgd!gws
From: gws@cbosgd.UUCP
Newsgroups: net.info-terms
Subject: silent 700 to rs232
Message-ID: <2083@cbosgd.UUCP>
Date: Tue, 6-May-86 10:42:12 EDT
Article-I.D.: cbosgd.2083
Posted: Tue May  6 10:42:12 1986
Date-Received: Fri, 9-May-86 10:26:00 EDT
Reply-To: gws@cbosgd.UUCP (Gary W. Sanders)
Organization: AT&T Bell Laboratories, Columbus
Lines: 14

I have several old TI silent 700 terminals that I would like to use
as logging printers on several LAN controlers. There are few messages
printed, so these 700 would serve well.. The problem is getting the
silent 700's up to an rs232 level. The 700's have a built in modem
110/300 baud. It also has a DB15 connector on the back. Does this
DB15 connector bring out any rs232 signals????? I dont care to much
about data signaling, just tx,rx and gnd.. Has anyone converted a
silent 700 to use on a normal rs232 line????? 

================================================================================
Gary W. Sanders		ihnp4!cbnap!gws		AT&T Bell Labs (Columbus)
72277,1325 (cis)				N8EMR @ WB8WGA	(packet radio)
614-860-5965 (w)				614-457-4595 (h)
================================================================================