Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxn!ihnp4!ucbvax!MITRE-BEDFORD.ARPA!sdl
From: sdl@MITRE-BEDFORD.ARPA (Steven D. Litvintchouk)
Newsgroups: net.micro.amiga
Subject: You CANNOT RUN SHELL FROM WORKBENCH!
Message-ID: <8605060051.AA27118@mitre-bedford.ARPA>
Date: Mon, 5-May-86 20:51:27 EDT
Article-I.D.: mitre-be.8605060051.AA27118
Posted: Mon May  5 20:51:27 1986
Date-Received: Thu, 8-May-86 21:42:14 EDT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The MITRE Corp., Bedford, MA
Lines: 27



	    I don't know why, but it doesn't work... it comes up and all that,
    but the does strange things, and dies when you exit.


OK, I promise to run your Shell V2 only from the CLI!  However, just
for the record, I want to reiterate that the *only* problem I had in
running Shell V2 from the Workbench (by mousing an associated icon)
was the inability of the Shell to pass the location of a named file to
built-in programs, unless the entire pathname (including the drive)
was given for the file.  I haven't experienced any other problems.

When exiting Shell V2 run from Workbench, I find that the window
closes cleanly, and everything else on the Workbench is fine....no
crashes or anything.  I compiled my copy of Shell V2 using Lattice C
and Workbench 1.1.  Perhaps Aztec C is the culprit....


Steven Litvintchouk
MITRE Corporation
Burlington Road
Bedford, MA  01730
(617)271-7753

ARPA:  sdl@mitre-bedford
UUCP:  ...{allegra,decvax,genrad,ihnp4,philabs,security,utzoo}!linus!sdl