Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2 9/5/84; site wang.UUCP
Path: utzoo!watmath!clyde!burl!ulysses!bellcore!decvax!wanginst!wang!ephraim
From: ephraim@wang.UUCP (pri=8 Ephraim Vishniac x76659 ms1459)
Newsgroups: net.micro.mac
Subject: Re: Re: Info requested on MacServe
Message-ID: <802@wang.UUCP>
Date: Wed, 7-May-86 13:05:47 EDT
Article-I.D.: wang.802
Posted: Wed May  7 13:05:47 1986
Date-Received: Fri, 9-May-86 11:07:40 EDT
References: <187@csun.UUCP> <752@hoptoad.uucp>
Distribution: net
Organization: Wang Labs, Lowell MA
Lines: 19

> Since I don't have an Appletalk network to try it out on, I can't vouch
> for MacServe's networking capabilities, but I can warn you of an
> incompatibility between it and the Parallel Printer Install program
> which comes from Apple Computer.

I've been using MacServe in "stand-alone" mode for a while and have run
into numerous printing problems:
	1.  With "Pr" (A. Shebanow's printing program), the cursor freezes.
		The job title (optionally printed by MacServe) is garbage.
	2.  With "PrSpool" (? - the printing program that comes with MacNosy),
		the cursor freezes.
	3.  When I print in normal or high quality, the word "TOO" appears
		here and there.  It's always in portrait orientation, even
		if I'm printing in landscape.
I've been remiss about reporting this stuff to Infosphere (at first I 
thought it was just a problem with Pr), so I don't have an official response.

Ephraim Vishniac
decvax!wanginst!wang!ephraim