Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxn!ihnp4!inuxc!pur-ee!uiucdcs!convex!smu!hu
From: hu@smu
Newsgroups: net.micro.pc
Subject: Helpneeded for 123 port setting
Message-ID: <15000030@smu>
Date: Sat, 17-May-86 13:53:00 EDT
Article-I.D.: smu.15000030
Posted: Sat May 17 13:53:00 1986
Date-Received: Mon, 19-May-86 07:09:12 EDT
Lines: 18
Nf-ID: #N:smu:15000030:000:817
Nf-From: smu!hu    May 17 12:53:00 1986


Hi, I have an IBM PC clone with parallel and serial ports. 
I load a PC mouse driver at the boot-up time and connect the
mouse via the serial port. Now, whenever I use lotus print graph
program, I found that Lotus always assume port #2 is the First serial
port while my other program (such as xtalk) look up for port #1 as
the serial port. As a result, I am not able to talk to my HP plotter
via the serial port. Whenever I direct the printgraph setup manual
to port #1 (which it thinks is a parallel port), the Plotter will be
initiated by will not respond to the following command. If I direct
the setup manual to port#2 (which it thinks is a serial port), the
print graph will  just hanging there asking me to "wait" forever.

Can any one help me in this matter?

Thanks in advance.

hu%smu.csnet@csnet-relay.arpa