Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!cbosgd!ihnp4!inuxc!pur-ee!pucc-j!pucc-h!pur-phy!kran!duncan!authorplaceholder
From: lawrence@duncan.UUCP
Newsgroups: net.micro.pc
Subject: Re: microemacs 3.6 on ibm pc with latti
Message-ID: <3200012@duncan>
Date: Mon, 19-May-86 19:41:00 EDT
Article-I.D.: duncan.3200012
Posted: Mon May 19 19:41:00 1986
Date-Received: Sun, 25-May-86 12:44:58 EDT
References: <165@sci.UUCP>
Lines: 26
Nf-ID: #R:sci.UUCP:-16500:duncan:3200012:000:1160
Nf-From: duncan.UUCP!lawrence    May 19 19:41:00 1986


>to compile under this lattice i had to remove the "realloc" function
>defined in line.c since this new version of lattice has a realloc and
>it does not like two of them.

	if you had defined LAT3 in estruct.h it would have not compiled
the realloc function.

>it does compile correctly and i've tried using several models. under
>small (64k code, 64k data supposedly) it runs just fine but is
>limited to about 28k of data. compiling unded the D model (64k code
>and 1 meg data) it runs horribly slow and it will not load the
>emacs.rc file (runs out of room!). under Large it is slower than D
>and in either case can't keep up with the repeat key for arrow.
>
>so, the question is; what model REALLY works and is there one that
>works on large files and handles redefined keys in .rc files and
>is fast enough to be useful?

	It is ment to run in the lattice D model. However, Lattice 3.0
is slower than 2.15 which I modified it for. Also MicroEMACS 3.7 when it
comes out in mid-late june has an IBMPC specific screen driver
optionally added which speeds it up considerably (less <1 sec screen replot)

				Daniel Lawrence
				ihnp4!itivax!duncan!lawrence