Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!mnetor!seismo!mcvax!ukc!cstvax!gdmr From: gdmr@cstvax.UUCP (George D M Ross) Newsgroups: net.bugs.4bsd Subject: Re: dmf driver problem Message-ID: <165@cstvax.UUCP> Date: Wed, 23-Jul-86 10:07:14 EDT Article-I.D.: cstvax.165 Posted: Wed Jul 23 10:07:14 1986 Date-Received: Thu, 24-Jul-86 21:45:12 EDT References: <131@pollux.UUCP> Reply-To: gdmr@cstvax.UUCP (George D M Ross) Organization: Comp. Sc., Edinburgh Univ., Scotland Lines: 21 In article <131@pollux.UUCP> pedz@pollux.UUCP writes: > >I am having problems with my dmf driver. This is on a Vax 11/750 >running 4.2bsd unix and concerns lines connected to out going modems. >..... We are seeing much the same problem with our 750 attached to our Gandalf PACX 2000, viz lines stopping responding to the modem signals. Any pointers to a solution would be most appreciated. We've tried using Chris Maloney's (MDDC) dmf driver, but that just wedged up the processor whenever we tried talking to the board (it's an Emulex one, by the way); if anyone has a version which works for our configuration (750, SI9900, a DEUNA, a couple of DZ11s, an Emulex board looking like a couple of DMF32s, and a mag-tape (TS11 look-alike?)) we'd be glad to hear from you. -- George D M Ross, Dept. of Computer Science, Univ. of Edinburgh, Scotland Phone: +44 31-667 1081 x2730 JANET: gdmr@UK.AC.ed.cstvax --> ARPA: gdmr@cstvax.ed.AC.UK UUCP: !ukc!cstvax!gdmr