Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!caip!nike!ucbcad!ucbvax!hplabs!amdahl!dwl10
From: dwl10@amdahl.UUCP (Dave Lowrey)
Newsgroups: net.micro.cbm
Subject: Re: C-Power problems with Fastload, request for C "fill" routine
Message-ID: <3444@amdahl.UUCP>
Date: Mon, 7-Jul-86 08:13:54 EDT
Article-I.D.: amdahl.3444
Posted: Mon Jul  7 08:13:54 1986
Date-Received: Tue, 8-Jul-86 05:02:34 EDT
References: <1325@garfield.UUCP>
Reply-To: dwl10@amdahl.UUCP (Dave Lowrey)
Organization: Amdahl Corporation, Columbia MD
Lines: 19

When using Fastload with C-Power, you need to do the following two
commands after booting the shell, and before and after running the
compiler: disk u;
          disk i0:

These commands reset the drive.

It is also a good idea to delete a .o file before re-compiling a
previously compiled program. cc uses save withb replace (shame on him!!!).
-- 
-------------------------------------------------------------------
                               Dave Lowrey

"So it goes, so it goes, so it goes, so it goes. But where it's
 going, nobody knows"   [Nick Lowe]
                                ...!{ihnp4,cbosgd,hplabs}!amdahl!dwl10

[ The opinions expressed <may> be those of the author and not necessarily
  those of his most eminent employer. ]