Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!lll-crg!lll-lcc!qantel!hplabs!pyramid!ucat!pesnta!amd!amdcad!amdimage!prls!philabs!prlb2!mcvax!ukc!dcl-cs!john
From: john@comp.lancs.ac.uk (John R. Nicol)
Newsgroups: net.research,net.unix
Subject: Problems with troff output on a SUN Laserwriter
Message-ID: <430@comp.lancs.ac.uk>
Date: Thu, 18-Sep-86 06:08:00 EDT
Article-I.D.: comp.430
Posted: Thu Sep 18 06:08:00 1986
Date-Received: Sun, 21-Sep-86 22:06:22 EDT
Reply-To: john@comp.lancs.ac.uk (John R. Nicol)
Organization: Department of Computing at Lancaster University, UK.
Lines: 27
Xref: mnetor net.research:419 net.unix:5571

I've prepared my Ph.D. thesis using troff and its me macro package. However,
I've run into problems in printing the formatted document on the SUN
laser-writer. I need a 1.5 inch left margin. But.... when I set the page
offset (.po) to 1.5i, troff goes bananas complaining that:

"Page offset + Line Length exceeds the width of the paper"

The resulting laser-written output is garbled too. Strange thing is the above
message is garbage: my line length (.ll) is 5.75i and I'm using standard British
A4 size paper. 

Apparently SUN know that troffing stuff with me intended for output on their
laser-writer is bug prone. This is no comfort to me! Has any bright spark
worked out a convenient way to get round this problem? Serious suggestions
are most welcome.

					John

"I'm desparate, Dan" (from "The Boys from the Black Stuff")
-- 
Segmentation fault (core dumped)...
------
EMAIL:	john@comp.lancs.ac.uk	  <--->  | Post: University of Lancaster,
UUCP:	...!mcvax!ukc!dcl-cs!john <-|    |	 Department of Computing,
Phone:	+44 524 65201 Ext. 4146   <-|    |	 Bailrigg, Lancaster, UK.
Reply to: John R. Nicol by  ________|    |	 LA1 4YR
Project: COSMOS Distributed Operating Systems Research