Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!lll-crg!mordor!sri-spam!sri-unix!hplabs!tektronix!reed!omsi
From: omsi@reed.UUCP (OMSI)
Newsgroups: comp.bugs.2bsd
Subject: 2.9 problems
Message-ID: <4511@reed.UUCP>
Date: Tue, 11-Nov-86 18:57:57 EST
Article-I.D.: reed.4511
Posted: Tue Nov 11 18:57:57 1986
Date-Received: Wed, 12-Nov-86 02:17:05 EST
Organization: Reed College, Portland OR
Lines: 15


	I've recently undertaken the task of trying to bring up the seismo
version of 2.9 (converting over from the original distribution).  I get the
system to come up, but when in multi-user mode, after a short while, I begin
to get "out of swap" errors left and right.  I've applied patches 1-16, and
a few unnumbered ones, but none seem to relate to this problem.  I vaguely
recall some discussion about this a while back, but don't recall if anything
was resolved.
	As a side note, I have a set of RL02 emulating drives (IOMEGA bernoulli
box with TD systems controller).  When the system tried to auto-configure
these, it hangs.  Removing the dtab entry  allows me to boot and use them.
Anyone else have this problem?

	Many thanks,
	Bob Ankeney   tektronix!reed!omsi