Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!think!nike!ucbcad!ucbvax!YALE.ARPA!ortiz-luis
From: ortiz-luis@YALE.ARPA
Newsgroups: mod.computers.apollo
Subject: [seth@CS.UCLA.EDU: GPR_$SET_FILL_PATTERN]
Message-ID: <8610221524.AA01828@yale-celray.YALE.ARPA>
Date: Wed, 22-Oct-86 11:24:48 EDT
Article-I.D.: yale-cel.8610221524.AA01828
Posted: Wed Oct 22 11:24:48 1986
Date-Received: Wed, 22-Oct-86 23:01:59 EDT
Sender: daemon@ucbvax.BERKELEY.EDU
Reply-To: seth@CS.UCLA.EDU
Organization: The ARPA Internet
Lines: 32
Approved: apollo@yale-comix.arpa


** Forwarded Message Follows **
Received: from yale-eli.YALE.ARPA (yale-eli.arpa.ARPA) by yale-celray.YALE.ARPA; Sat, 18 Oct 86 18:58:03 edt
Received: from hera.CS.UCLA.EDU (14026180) by yale-eli.YALE.ARPA; Sat, 18 Oct 86 12:07:10 edt
Received: by hera.CS.UCLA.EDU (Sendmail 5.51/5.14)
	id AA24441; Sat, 18 Oct 86 15:47:02 PDT
Message-Id: <8610182247.AA24441@hera.CS.UCLA.EDU>
To: apollo
Subject: GPR_$SET_FILL_PATTERN
Date: Sat, 18 Oct 86 15:47:00 PDT
From: seth@CS.UCLA.EDU

I'm stumped!  I am trying to use this routine and always get
an error claiming that I'm passing in an illegal bitmap.  I
create an 8x8 bitmap and put a pattern into it.  I also give
it an attribute block.  Then I call this routine:

gpr_$set_fill_pattern(bitmap, 1, sts)

and sts comes back with an error.

Any suggestions?  Does this routine really work?

						Seth Goldman

ARPA:   seth@LOCUS.UCLA.EDU
UUCP:   ...!{ihnp4,cepu,trwspp,sdcrdcf,ucbvax}!ucla-cs!seth
USMail: A.I. Lab, 3531 Boelter Hall, UCLA, Los Angeles, CA  90024  
MaBell: (213) 825-5199


** End Forwarded Message **