Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!rutgers!husc6!seismo!mcvax!cernvax!jmg
From: jmg@cernvax.UUCP
Newsgroups: comp.sys.atari.st
Subject: gnuplot on ST in native mode
Message-ID: <397@cernvax.UUCP>
Date: Thu, 27-Nov-86 10:11:53 EST
Article-I.D.: cernvax.397
Posted: Thu Nov 27 10:11:53 1986
Date-Received: Fri, 28-Nov-86 01:59:08 EST
Reply-To: jmg@cernvax.UUCP ()
Distribution: world
Organization: CERN European Laboratory for Particle Physics, CH-1211 Geneva, Switzerland
Lines: 7
Keywords: gnuplot, graphics

I have been impressed with running gnuplot (see net.sources) on a host to
which I connected with Uniterm. Apart from the fact that Uniterm is left
in Tektronix mode on quitting, it looks great. I am considering putting
in the mods to make it run on an ST in native mode (I have Megamax).
However, years of experience tell me that all ideas are either bad or have
already been implemented. Question therefore: has anyone already done it?
If so, what are the necessary routines needed in term.c?