Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!lll-crg!styx!lll-lcc!ptsfa!well!tenney
From: tenney@well.UUCP (Glenn S. Tenney)
Newsgroups: comp.sys.mac
Subject: Re: Summary of answers to my laserwriter questions
Message-ID: <2079@well.UUCP>
Date: Fri, 21-Nov-86 05:01:09 EST
Article-I.D.: well.2079
Posted: Fri Nov 21 05:01:09 1986
Date-Received: Fri, 21-Nov-86 08:46:35 EST
References: <9447@sun.uucp>
Reply-To: tenney@well.UUCP (Glenn S. Tenney)
Distribution: net
Organization: Whole Earth Lectronic Link, Sausalito CA
Lines: 9

Sorry to have not answered much earlier, but here is a quick comment:
I used a MacPlus and Laserwriter for a month (I've had my Mac for
quite a while).  The ONLY problem I encountered was that MacPaint
could *NOT* be printed using manual feed (or any other options
normally found using page setup).  I had a drawing I wanted to print
on very heavy stock and just was not able to do it!  Ok, I could
cut it and paste into a draw doc, but be serious!

Glenn Tenney