Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!watmath!mnetor!seismo!rutgers!sri-spam!ames!ucbcad!zen!cory.Berkeley.EDU!korn From: korn@cory.Berkeley.EDU.UUCP Newsgroups: comp.sys.mac Subject: Re: InfoWorld this week covers LANs and LaserPrinters Message-ID: <1092@zen.BERKELEY.EDU> Date: Fri, 21-Nov-86 23:45:24 EST Article-I.D.: zen.1092 Posted: Fri Nov 21 23:45:24 1986 Date-Received: Sat, 22-Nov-86 06:49:22 EST References: <4331@ut-ngp.UUCP> Sender: news@zen.BERKELEY.EDU Reply-To: korn@cory.Berkeley.EDU.UUCP (Peter "Arrgh" Korn) Organization: University of California, Berkeley Lines: 45 Keywords: TOPS MacServe My particular experience with TOPS has been in the following configuration: 1 Epson Equity II (DOS machine), 1 Mac plus, and 1 LaserWriter; all connected via the Farralon PhoneNet, spread over a linearly configured network in the order listed above. I encountered my first problem when I tried to print to the LaserWriter. It turns out that the Epson (and I presume all DOS machines) gives off too much noise to go the distance to the LaserWriter gracefully. I had to purchase terminating resisters for the PhoneNet ($0.50 ea), which handily solved the problem. The next problem has to do with programs that output PostScript. All of them expect to be talking directly to the LaserWriter. None of them expect to have the print file sent batch, with the prep file concatenated with the body (one of the programs, Personal Publisher, has PostScript code in the prep file that tells the LaserWriter specifically to go into 9600 baud, and to accept input from the serial port). Of all the programs I've tested, I've only gotten MS-Word 3.0 to work (the other program I tried was WordPerfect 4.2, which will now drive PostScript printers). Centram is now shipping TopsPrint, which should not only take care of this problem, but should also create PostScript code from *any* program that can drive an Epson FX-80/85. When I get ahold of that, I'll post my comments. My last complaint about TOPS is speed. If the IBM/clone's hard drive is pretty full, response time goes down I've found. The Epson Equity II that I use has ~600K free on it's Seagate 20 Mbyte drive. Publishing it (telling the rest of the network that there's a new drive on the block) can take over 3 minutes. The mac directory of that hard drive is about 1.5 Mbytes long, so perhaps part of this time is due to MS-Dos mac partitions being MFS volumes, but still... However, with all of these gripes, I'm still very impressed with TOPS, and highly recommend it. Once TopsPrint is out, and the new version of MacLink (which will support file transfer/translation over TOPS) is available, TOPS will become THE PC-Mac bridge/network. Peter ----- Peter "Arrgh" Korn I know lots of honorary jews! Why, korn@ucbvax.Berkeley.EDU some of my very best friends {decvax,dual,hplabs,sdcsvax,ulysses}!ucbvax!korn are honorary jews!