Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!lll-crg!nike!ucbcad!ucbvax!VTVAX5.BITNET!JARRELLRA
From: JARRELLRA@VTVAX5.BITNET (Ronald A. Jarrell)
Newsgroups: mod.computers.vax
Subject: set host/dte
Message-ID: <8610301341.AA02849@ucbvax.berkeley.edu>
Date: Thu, 30-Oct-86 09:04:33 EST
Article-I.D.: ucbvax.8610301341.AA02849
Posted: Thu Oct 30 09:04:33 1986
Date-Received: Thu, 30-Oct-86 23:46:32 EST
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 23
Approved: info-vax@sri-kl.arpa



I have a horrible time getting this to work.  I have a hayes modem
connected to a tt port.  Kermit can see tha modem fine, let me dial out,
let me do my work, etc.  I'd like to use set host/dte.  Uh-uh.  That
let's me get to the modem, but I never see anything come back.. The modem
is sending it to the system, cause if i drop out of set host and jump
into kermit, I can see that my data was getting there and I start
getting output from that point.  If I switch back to set host, no data.
Needless to say, this makes it impossible to use dynamic decnet...

Any ideas on why this happens?  Do I need a magic cable? (I've tried
2-3-7, and all 50) Magic terminal settings?  (various combinations
tried, including modem and nomodem and parity and bit settings.)

Help!

I especially need this now, cause that system is isolated from the rest
of campus due to that fact that its ethernet cable caught fire. (Don't
ask, it's hard to explain, just trust me.)  Getting that connection back
would pick up 5 systems that are stuck right now.

-Ron