Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!rutgers!lll-lcc!ptsfa!cogent!mark
From: mark@cogent.UUCP
Newsgroups: comp.unix.questions,comp.sources.d
Subject: Re: Program runs under sdb, but when called direct?!?!
Message-ID: <140@cogent.UUCP>
Date: Sat, 17-Jan-87 01:33:30 EST
Article-I.D.: cogent.140
Posted: Sat Jan 17 01:33:30 1987
Date-Received: Sat, 17-Jan-87 16:14:13 EST
References: <1024@chinet.UUCP>
Reply-To: mark@cogent.UUCP (Mark Steven Jeghers)
Organization: Cogent Software Solutions, Stockton, CA
Lines: 20
Xref: watmath comp.unix.questions:666 comp.sources.d:167

In article <1024@chinet.UUCP> megabyte@chinet.UUCP (Dr. Megabyte) writes:
>I have a program, the recent VC spreadsheet program on my 
>AT&T 3b2/400 with SVR2.  I compiled it without errors.  When I
>try to run it, the program does nothing, so I treid to use
>the sdb debugger on it.  When I used "sdb vc" and then issued
>the "r" command to run the program, it ran fine!!

When I try to run vc on my HP 840 running HP-UX (port of SVR2),
vc works until I try to enter a number.  It dies with a memory
fault upon the RETURN key.
-- 
+----------------------------------------------------------------------------+
|     Mark Steven Jeghers         ECHOMPGULP - process has eaten it          |
| cryptography, terrorist, DES, drugs, cipher, secret, decode, NSA, CIA, NRO |
|                                                                            |
|     {ihnp4,cbosgd,lll-lcc,lll-crg}|{dual,ptsfa}!cogent!mark                |
|                                                                            |
| Cogent Software Solutions can not be held responsible for anything said    |
| by the above person since they have no control over him in the first place |
+----------------------------------------------------------------------------+