Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!nbires!isis!udenva!rbourass
From: rbourass@udenva.UUCP (Mr. Photography)
Newsgroups: comp.sys.m6809
Subject: RS232 Pak
Message-ID: <2749@udenva.UUCP>
Date: Fri, 16-Jan-87 19:12:12 EST
Article-I.D.: udenva.2749
Posted: Fri Jan 16 19:12:12 1987
Date-Received: Sun, 18-Jan-87 01:41:32 EST
Organization: U of Denver
Lines: 27

HELP!!!!!!!!!!!

I just bought an upgrade to a terminal program that claimed it would 
recognize and use an RS232 PAK. This was all the ad said, but when I
received the upgrade, the instructions said to put the RS232 in the
slot next to the drive card in the multipak.

PROBLEM:

My RS232 and drive card are on a Y-cable. I do not have a multipak.
The RS232 has pin 8 cut and the useless Shack Program rom pulled out
to allow it to function on the Y-cable with the drive card. It works
fine on Mikey Term and Greg Miller's new Greg-E-Term, but the above
mentioned program will not recognize or use the RS232!!!

Can anyone PLEASE give me an answer as to how I can fool the program
into thinking the RS232 card is in the slot on the multipak. The program
is highly protected so I can not break in to tell it to go to the RS232
card.

The source of my problems==>   AUTO TERM 5.0

If anyone can help, I would REALLY appreciate it.

Thanks in advance...
Richard Bourassa
University of Denver