Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watnot!watmath!clyde!rutgers!seismo!rochester!ritcv!rocksvax!joec
From: joec@rocksvax.UUCP
Newsgroups: comp.sys.apple
Subject: Re: Joystick pinouts.
Message-ID: <811@rocksvax.UUCP>
Date: Fri, 20-Feb-87 10:21:23 EST
Article-I.D.: rocksvax.811
Posted: Fri Feb 20 10:21:23 1987
Date-Received: Sat, 21-Feb-87 10:19:27 EST
References: <8702152306.AA13704@cdfc.toronto.edu>
Organization: Xerox: Henrietta, NY
Lines: 35

> 
>  
> Here are the connections that you will need to convert a //e or //c joystick
> for use in a //+, or vice versa.
>  
> 16 pin DIP (Apple //+)     connection           DB-9 (//e, //c...)
>  
>         1                       +5v                     2
>         2                       PB0                     7
>         3                       PB1                     1
>         6                       GC0                     5
>         8                       GND                     3
>        10                       GC1                     6
>  
> For joystick purposes, you can leave all the other ones unconnected.
>  
> I hope this helps!
>  
> --Tak Ariga
>  
> -----------------------------------------------------------------------------
> UUCP:     {utzoo, decvax, ihnp4, cbosgd, utcsri, mnetor}!utcs!utcdfa!a228arig
> ARPAnet:  a228arig%cdfa.toronto.edu@relay.cs.net
> CSnet:    a228arig%cdfa.toronto.edu
> BITNET:   utoronto%"a228arig@cdfa.utoronto"     (<- with some luck)
> ==  University of Toronto -- Toronto, Canada  ==
> -----------------------------------------------------------------------------


 I need a little more information. The joystick I have is a TG products one 
 with balance and two buttons and stick. Internally the joystick has a potentimeter
 with three solder joints on one side and three on the other. Then the buttons 
 have two soder joints each with  two resistors joining them. Before my joystick
 fell apart I remember two wires going to one side of the three connector
 and another two to the other. Then one wire went to each of the buttuns and one to the center point where the two resistors meet. Ineed to know which pin of the 9 pin joystick goes where.