Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watnot!watmath!clyde!cbatt!ihnp4!houxm!mhuxt!mhuxm!mhuxo!ulysses!faline!thumper!sdh
From: sdh@thumper.UUCP
Newsgroups: comp.sys.apple
Subject: Re: Simple Question on 'I' programs
Message-ID: <421@thumper.UUCP>
Date: Fri, 27-Feb-87 10:16:36 EST
Article-I.D.: thumper.421
Posted: Fri Feb 27 10:16:36 1987
Date-Received: Sun, 1-Mar-87 14:46:50 EST
References: <2530@mtuxo.UUCP>
Distribution: na
Lines: 18
Summary: provide the answer to the question

In article <2530@mtuxo.UUCP>, wjc@mtuxo.UUCP (w.cambre) writes:
> 			Unfortunately most of them show up (in the
> CATALOG command) as type 'I', not 'A' or 'B'.  So how do I get them
> to run?  RUN works for 'A', BRUN works for 'B', ?? works for 'I'?
>  - confused.     (Bill Cambre)  {ihnp4!}mtuxo!wjc

I stands for Integer Basic.   Some of us remember when that's all the Apple ][
had to offer in the way of high (ha-ha) level programming languages.  In
order to run integer basic programs you will need either an Integer Basic
Firmware card, replace your applesoft ROMs with Integer Basic ROMs, or
a 16K ram card.  If you boot the DOS 3.3 system master, it should
automatically load Integer basic into the Ramcard, and allow you to run
those programs.

To see if you have it installed, just type 'INT' and the prompt should
change from ']' to '>'.

Retief of the CDT