Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watnot!watmath!clyde!rutgers!mit-eddie!genrad!decvax!ucbvax!sdcsvax!sdcc6!sdcc12!st69
From: st69@sdcc12.UUCP
Newsgroups: comp.sys.atari.st
Subject: prototyping boards for the cartridge port (a correction)
Message-ID: <794@sdcc12.ucsd.EDU>
Date: Thu, 12-Mar-87 11:44:05 EST
Article-I.D.: sdcc12.794
Posted: Thu Mar 12 11:44:05 1987
Date-Received: Fri, 13-Mar-87 21:36:26 EST
Organization: University of California, San Diego
Lines: 18


Oops...  I made a mistake in my previous posting.  The board from
Douglas Electronics is not for EPROMs only, but is a generic prototyping
board (which could be used with EPROMS, of course).  It has holes spaced
at 0.10 inches, 20 rows by 30 columns, with 8 rows dedicated to the power
and ground busses.  It fits the cartridge port perfectly.  Here is the full
info on Douglas Electronics:

	Douglas Electronics
	718 Marina Blvd.
	San Leandro, CA 94577
	415-483-8770
	Visa and Mastercard accepted

Again, the part number for the board is 33-DE-40, it cost $10.00, and it
took 2 days from when I placed the order to when I got delivery.

Tom Erbe (uucp: ucbvax!sdcarl!tre, genie: T.ERBE)