Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!rutgers!sri-spam!ames!cit-vax!usc-oberon!sdcrdcf!psivax!csun!cs1!cbcscmst
From: cbcscmst@cs1.UUCP (Michael Steven Temkin)
Newsgroups: comp.sys.cbm,misc.wanted
Subject: 1541 schematic
Message-ID: <309@cs1.UUCP>
Date: Sun, 8-Mar-87 17:47:35 EST
Article-I.D.: cs1.309
Posted: Sun Mar  8 17:47:35 1987
Date-Received: Tue, 10-Mar-87 21:44:27 EST
Distribution: comp
Organization: Calif State Univ, Northridge, Computer Science Dept
Lines: 12
Xref: mnetor comp.sys.cbm:243 misc.wanted:644

(Here liney liney liney... Where is that line eater?!)

     I have need of a 1541 service-manual with schematic and test
procedures.  My problem is this: after the disk is on for a short
while (~15 minutes) it locks up while loading a program.  After the
LOAD-command the system responds with its "Searching for" messages and
then just sits there, with the drive still spinning.  I've replaced
the 12-volt regulator and the 74LS14 (hex-inverter) chip, with no luck.
Any ideas or suggestions would be appreciated.

Thanks in advance,
			Mike