Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!utgpu!water!watnot!watmath!clyde!cbatt!ihnp4!ptsfa!lll-lcc!seismo!mimsy!oddjob!hao!noao!mcdsun!asuvax!system From: system@asuvax.UUCP Newsgroups: comp.unix.wizards,comp.unix.questions Subject: Versatec downs UNIBUS under 4.3bsd Message-ID: <120@asuvax.UUCP> Date: Fri, 27-Feb-87 15:50:06 EST Article-I.D.: asuvax.120 Posted: Fri Feb 27 15:50:06 1987 Date-Received: Mon, 2-Mar-87 21:14:19 EST Organization: Arizona State Univ, Tempe Lines: 31 Keywords: versatec unibus Xref: utgpu comp.unix.wizards:1186 comp.unix.questions:1238 We recently upgraded from 4.2 to 4.3 on our VAX 780 and have not been able to get the versatec to run correctly. When the versatec starts to print, the system will respond with : uba0: uba error sr=3000002 fmer=0 fubar=760514 uba0: uba error sr=7000002 fmer=0 fubar=760100 uba0: uba error sr=7000002 fmer=0 fubar=760104 uba0: uba error sr=7000002 fmer=0 fubar=760100 uba0: too many zero vectors (5001 in <2 sec) IPL 0x15 cnfgr: 2000 Adapter Code: 0x28 sr: 7000002 dcr: 8010028 (MIC OK) uba0: reset dz0 dz1 dz2 dz3 vp0 lp0 dmf0 dmf1 dmf2 dmf3 This will knock lp0, the dz's, and the dmf's offline, but vp0 will continue to print. We moved vp0 to our second unibus and it knocks the our uda and disk drives offline. In both cases, we have to hard crash the machine and reboot with the versatec turned off. If I boot under our old 4.2 disk, the versatec runs fine. Has anyone run into this problem or have a fix? ------------------------------------------------- Marc Lesure System Manager Engineering Computer Center Arizona State University Tempe, Arizona UUCP: ...!ihnp4!noao!mcdsun!lesure CSNET: lesure@asu ARPA: lesure%asu@csnet-relay