Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!elsie!ado
From: ado@elsie.UUCP (Arthur David Olson)
Newsgroups: comp.unix.wizards
Subject: write retries exceeded with tc7000 & cipher M990
Message-ID: <7351@elsie.UUCP>
Date: Thu, 5-Mar-87 20:53:29 EST
Article-I.D.: elsie.7351
Posted: Thu Mar  5 20:53:29 1987
Date-Received: Sat, 7-Mar-87 22:44:48 EST
References: <43125@beno.seismo.CSS.GOV>
Organization: NIH-LEC, Bethesda, MD
Lines: 30

> I have a Vax 11/780 running 4.3BSD with an Emulex TC13 controller
> (emulating a ts-11) connected to a Fuji-2444AC tape drive.
> 
> Everything works fine except. . .Emulex swears that if the driver sets the
> right bit. . .(It's always a driver problem to them.)
>
> Has anyone tried to do a software density select with an Emulex TC13?

Me, I have a VAX 11/750 running MORE/bsd 4.3 with an Emulex TC7000 controller
(emulating a tm03/tu77) connected to a Cipher M990 tape drive.

Everything works fine except when a bad tapes causes a "write retries exceeded"
error on the Cipher drive.  It seems as if in such cases there's no interrupt
getting back to the VAX to tell it there's a problem and that the write should
be aborted.  Even after we clear the error on the drive itself (by unloading
and reloading the tape) we don't get an interrupt--and since the 4.3BSD driver
is very patient about waiting for one (read:  it will wait forever), the only
way to make the drive useable again is to reboot.

And I'm so low on Emulex's list that they don't even swear at me--
my calls to the technical types have simply gone unreturned all week.

Has anyone solved the write retries problem with the TC7000/M990 combination?

P.S.:  Software density select works just fine with the TC7000.  :-)
--
UNIX is a registered trademark of AT&T Bell Laboratories.
--
	UUCP: ..decvax!seismo!elsie!ado   ARPA: elsie!ado@seismo.ARPA
	DEC, VAX, Elsie & Ado are Digital, Borden & Ampex trademarks.