Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!watmath!clyde!rutgers!princeton!allegra!ulysses!ucbvax!jimi.cs.unlv.edu!robert
From: robert@jimi.cs.unlv.edu.UUCP
Newsgroups: mod.computers.vax
Subject: (none)
Message-ID: <8702030305.AA13757@ucbvax.Berkeley.EDU>
Date: Sun, 1-Feb-87 18:06:00 EST
Article-I.D.: ucbvax.8702030305.AA13757
Posted: Sun Feb  1 18:06:00 1987
Date-Received: Wed, 4-Feb-87 01:37:38 EST
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 35
Approved: info-vax@sri-kl.arpa

Newsgroups: mod.computers.vax
Subject: Re: LNO3+ command files, etc.
Summary: 
Expires: 
References: <12274865587.27.STEINBERGER@SRI-KL.ARPA>
Sender: 
Reply-To: robert@jimi.CS.UNLV.EDU.UUCP (Robert Cray)
Followup-To: 
Distribution: 
Organization: University of Nevada, Las Vegas
Keywords: 

In article <12274865587.27.STEINBERGER@SRI-KL.ARPA> STEINBERGER@SRI-KL.ARPA (Richard Steinberger) writes:
>
>I have just installed a DEC LNO3+ laser printer on a uVAX-II.  Does anyone
>have any command files, or other aids that allow users to conveniently
>select fonts and/or switch to and from landscape mode (if this is possible)?

The way I do it is just say print/setup=landscape, assuming there is a module
called landscape in sysdevctl.tlb that has the escape sequence for landscape.
The problem with this is that the printer is left in landscape, so I just
made an alias laser which is print/setup=reset, which resets the printer
TeX files just get printed with normal print.

It is also good to have an alias because if you say print/setup=landsape
i.e. mispelled, it will print the error message on the printer, not your
terminal.  I don't remember where sysdevctl is, I think sys$library

					--robert


--
CSNET:   robert%jimi.cs.unlv.edu@relay.cs.net
UUCP:    {sdcrdcf,ihnp4}!otto!jimi!robert
         seismo!unrvax!tahoe!jimi!robert