Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watnot!watmath!clyde!cbatt!ucbvax!UTAH-CS.ARPA!cetron%utah-ced
From: cetron%utah-ced@UTAH-CS.ARPA.UUCP
Newsgroups: mod.computers.vax
Subject: Re:  Has anyone successfully put 2 DEQNAs on a microVAX???
Message-ID: <8702202031.AA04940@utah-ced.ARPA>
Date: Fri, 20-Feb-87 15:31:11 EST
Article-I.D.: utah-ced.8702202031.AA04940
Posted: Fri Feb 20 15:31:11 1987
Date-Received: Sat, 21-Feb-87 10:47:16 EST
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 21
Approved: info-vax@sri-kl.arpa

1. make sure you changed the hardware address on the second deqna by
	moving jumper W1 over to the second position.  The vector is
	downloaded by the driver, the csr is not.  Moving W1 will move
	the csr from 17774440 to 17774460 which is correct (and fixed.)

2. Make sure W2 is out, and W3 is in... (bus request holdoff enabled, sanity
	timer disabled)

3. make sure both deqna's are up to rev level e1 (stamped on the magenta
	handle)

4. watch both deqna's at power up and verify all led's go off.

5. use the configure command in sysgen to find the correct floating vector
	assignment for xqb.....I wouldn't trust Colorado Springs....

-ed cetron
center for engineering design
univ of utah
cetron@utah-cs.arpa
cetron@utahcca.bitnet