Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watnot!watmath!clyde!rutgers!ames!ucbcad!ucbvax!DOCKMASTER.ARPA!TMPLee
From: TMPLee@DOCKMASTER.ARPA.UUCP
Newsgroups: comp.sys.apple
Subject: Apple Kermit 3.75
Message-ID: <870402070748.880978@DOCKMASTER.ARPA>
Date: Thu, 2-Apr-87 02:07:00 EST
Article-I.D.: DOCKMAST.870402070748.880978
Posted: Thu Apr  2 02:07:00 1987
Date-Received: Sat, 4-Apr-87 13:35:51 EST
Sender: daemon@ucbvax.BERKELEY.EDU
Distribution: world
Organization: The ARPA Internet
Lines: 12

Tried installing apple kermit 3.75 from the nosc-shark files.
(INSTALL1-5) It works fine as a communications handler; haven't tried
the VT52 emulation yet.  Can't get it to transfer files to this system
(a multics system reached via GTE Telenet).  The two systems can't seem
to negotiate the parameters (fails on first or second packet.)  Note
that this system (Dockmaster) works just fine on MS-Kermit.  Further
note:  if I try to turn flow control (xon&xoff) on, things really fall
apart -- get garbage characters.  My micro is a II+, super serial card,
hayes modem, viewmaster 80-col card, off-brand of aftermarket full ASCII
keyboard.  Note that the configuration works just fine with AExpress.
Should I give up and fall back to an earlier version?  (I haven't been
tracking all the traffic.)