Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watnot!watmath!clyde!rutgers!seismo!mcvax!ukc!warwick!donald
From: donald@warwick.UUCP
Newsgroups: comp.sys.atari.st
Subject: running Uniterm from a CLI
Message-ID: <514@ubu.warwick.UUCP>
Date: Wed, 1-Apr-87 13:32:48 EST
Article-I.D.: ubu.514
Posted: Wed Apr  1 13:32:48 1987
Date-Received: Sun, 5-Apr-87 04:36:21 EST
Organization: Need-to-know Software/The Donald project
Lines: 23
Keywords: Uniterm,CLI


   Has anybody out there been able to run Uniterm from the COMMAND.TOS
command line interpreter? This is reeeelly important to me.  I wrote a
little C (Mark Williams)program which hid the text cursor and revealed
the mouse pointer before Pexec-ing Uniterm, but all you could do was
wave the pointer around, clicking on buttons and sliding over menu
titles had no effect. 
   Do I need to initialise the mouse in any special way? I am puzzled
because running the same program from the Mark Williams shell works
perfectly. 
   Could you mail me any ideas, even if you decide to post them, as we only
get a small percentage of articles in any given group arriving here, and
I have often seen replies to replies to my postings without seeing the
replies - very confusing!
   Thanks in advance,
Tim

-- 
/*
 * Tim Bissell ... the six million donald man ...
 * 			           donald@uk.ac.warwick
 *            ...mcvax!ukc!warwick!donald
 */