Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!rutgers!umnd-cs!umn-cs!hyper!mark
From: mark@hyper.UUCP (Mark Mendel)
Newsgroups: comp.mail.uucp
Subject: REQUEST: help w/ smail/sendmail/TCP
Message-ID: <243@hyper.UUCP>
Date: Mon, 4-May-87 12:01:31 EDT
Article-I.D.: hyper.243
Posted: Mon May  4 12:01:31 1987
Date-Received: Tue, 5-May-87 05:38:10 EDT
Organization: Network Systems Corp., Mpls. MN
Lines: 27
Keywords: help,smail,sendmail,TCP

I can't get sendmail/smail configured correctly.

We have a bunch of MicroVAXen running Ultrix 1.2, which is essentially BSD4.2,
and a local area network.  Only one host dials out. 

I would like to set up smail on all the machines so that:

1) internal mail is sent via SMTP directly to the local host.
2) all other mail goes via SMTP to the dial-out host (gateway?).  This host
only has enough disk space to know about routes to a few hosts, but one of
these is a smarthost.

I set up /bin/lmail to be the original /bin/mail, which I think is the Berkley
mailer (though distinct from /usr/ucb/Mail).
/bin/mail was replaced by a link to /bin/smail.
Is this right?

Can someone send me a /usr/lib/sendmail.cf file and a /usr/lib/uucp/paths file
that will work?  I would like it to work without registering a domain.  If
this works then we will register.

Thanks in advance!
-- 
Mark G. Mendel, ihnp4!umn-cs!hyper!mark,  Network Systems Corporation

All opinions expressed herein, even the most arbitrary, are defended by my 
employer with religious fervor.