Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watmath!clyde!rutgers!princeton!siemens!gypsy!glu
From: glu@gypsy.UUCP
Newsgroups: comp.sys.amiga
Subject: Re: Re: Would like information about "In
Message-ID: <6100002@gypsy.UUCP>
Date: Wed, 22-Apr-87 08:52:00 EST
Article-I.D.: gypsy.6100002
Posted: Wed Apr 22 08:52:00 1987
Date-Received: Sat, 25-Apr-87 11:59:57 EST
References: <1203@ulowell.UUCP>
Lines: 16
Nf-ID: #R:ulowell:-120300:gypsy:6100002:000:690
Nf-From: gypsy!glu    Apr 22 08:52:00 1987


[please please eat me, line eater]

Insider does auto config if it is mapped to address C00... You have to run
a special "addmem" program if you set it to anywhere else. If you have
other ram boards or whatevers that also auto configure on the same address,
which seems to be pretty common, then you are stuck, you have to configure
explicitly during startup.

WARNING. Nobody told me when I bought Insider that it might not fit into
my Amiga. I had to take a hacksaw and chop off part of the disk housing,
which overhang quite a bit, to get Insider installed. I was pretty annoyed
at that time - but now it works and I am very happy with it.

Raimund Gluecker
princeton!siemens!gypsy!glu