Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!lll-lcc!ames!ucbcad!ucbvax!HI-MULTICS.ARPA!Giebelhaus
From: Giebelhaus@HI-MULTICS.ARPA
Newsgroups: comp.sys.apollo
Subject: HELP: Can't restore from Megatape
Message-ID: <870503052439.756066@HI-MULTICS.ARPA>
Date: Sun, 3-May-87 01:24:00 EDT
Article-I.D.: HI-MULTI.870503052439.756066
Posted: Sun May  3 01:24:00 1987
Date-Received: Sun, 3-May-87 18:42:02 EDT
Sender: daemon@ucbvax.BERKELEY.EDU
Distribution: world
Organization: The ARPA Internet
Lines: 26

I cannot restore my files from a megatape 750 tape drive.  I can index
the files and they are there, but I seem to be running into some sort of
memory problem with heap_$get.  The error message I get is:
heap_$get: Heap table is full.

I have a dsp80 with two CDC 300 meg drives on it.  The dsp 80 is named
//library.  I issued the following command to back it up:
wbak -f 1 //library -l
The megatape is on a dsp 90 so it was all copied over the network.  The
backup took just barely over one 750 tape.  

I then invol'ed the drive and am trying to get the data back on the
drive.  I tried:
rbak -f 1 //library/userb -as //library/userb -md -l -sacl -pdt
This starts to work fine, but after a while I get the heap_$get error.
I have to use the "-as" because after the invol, the disk has a
different uid.  

On the index of the tape, the //library/user directory is after the
userb directory.  When I try to restore the userb directory I get the
heap_$get error even before it starts the restore.  

If anyone can tell me how to get around this error, I would be very
grateful.  

Arpa: Giebelhaus@HI-MULTICS.ARPA: