Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!gatech!gitpyr!jkg
From: jkg@gitpyr.gatech.EDU (Jim Greenlee)
Newsgroups: comp.sys.att
Subject: Re: 6300 mouse and QuickBasic
Message-ID: <3516@gitpyr.gatech.EDU>
Date: Fri, 1-May-87 10:34:12 EDT
Article-I.D.: gitpyr.3516
Posted: Fri May  1 10:34:12 1987
Date-Received: Sat, 2-May-87 15:16:23 EDT
References: <439@mcdchg.UUCP>
Reply-To: jkg@gitpyr.UUCP (Jim Greenlee)
Organization: Georgia Institute of Technology
Lines: 25

In article <439@mcdchg.UUCP> heiby@mcdchg.UUCP (Ron Heiby) writes:
> [...] Is there
>some dumb configuration option I need to use?  Or, do I have an obsolete
>set of mouse software?  Or, should I just go out and plunk down $100 on
>a real Microsoft Mouse?  (And, is the Microsoft Bus mouse ok in the 6300?)

I don't know about configuring your AT&T (actually Logi-) mouse, but I've
been using a Microsoft Bus Mouse V5.03 on my 6300 for over 6 months with no
problems whatsoever. PC-Paint and Menu (a program that allows you to create
mouse interfaces for programs that don't support a mouse) also work.

I polled the net right before I bought it and the consensus seemed to be 
the best mouse to use was the Logimouse C7 (available only in the serial
version then), with MS Mouse running a close second. Since I didn't want 
to give up my serial port, I opted for the MS Mouse. Logitech has since
come out with a bus version of the C7. I don't know anything about it, but
it might be worth checking into.

						Jim Greenlee

-- 
The Shadow...!{akgua,allegra,amd,hplabs,ihnp4,seismo,ut-ngp}!gatech!gitpyr!jkg

Jryy, abj lbh'ir tbar naq qbar vg! Whfg unq gb xrrc svqqyvat jvgu vg hagvy lbh
oebxr vg, qvqa'g lbh?!