Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!ut-sally!utah-cs!cetron
From: cetron@utah-cs.UUCP (Edward J Cetron)
Newsgroups: comp.org.decus
Subject: Re: vt100 (cit101) printer port
Message-ID: <4583@utah-cs.UUCP>
Date: Fri, 22-May-87 12:36:08 EDT
Article-I.D.: utah-cs.4583
Posted: Fri May 22 12:36:08 1987
Date-Received: Sat, 23-May-87 15:59:16 EDT
References: <8705221232.AA19214@ucbvax.Berkeley.EDU>
Reply-To: cetron@utah-cs.UUCP (Edward J Cetron)
Organization: Center for Engineering Design, Univ of Utah
Lines: 22

it wants tx,rx and the two gnds.  the others dtr/dsr/rts/cts are selectable in
the menu.

here is a quick key of printer port control sequences:

for a one line dump to printer port:  shift pf1
for a one page dump: cntrl pf1
for 'auto line mode': cntrl pf2
printer port input to display:	shift cntrl pf3
printer port input to comm port output:	shift cntrl pf2
comm port input to printer port output:	cnrtl pf3
	this also disables comm port input to display
keyboard input to printer port output: shift pf2 disabled by shift pf3
keyboard input to comm port output:	shift pf3 disable by shift pf2
keyboard input to display and printer port output: cntrl pf4
	which also lets comm port input to display and printer port
printer port input to display:	shift cntrl pf3

disable ALL auxiliary input modes: shift cntrl pf4
disable ALL auxiliary output modes (except one line and one page dumps):
				shift pf4

-ed