Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!rutgers!ames!oliveb!pyramid!decwrl!ucbvax!TRINCC.BITNET!TRIN7
From: TRIN7@TRINCC.BITNET
Newsgroups: comp.os.vms
Subject: decserver200 question
Message-ID: <8705301433.AA15534@ucbvax.Berkeley.EDU>
Date: Fri, 29-May-87 01:27:00 EDT
Article-I.D.: ucbvax.8705301433.AA15534
Posted: Fri May 29 01:27:00 1987
Date-Received: Mon, 1-Jun-87 05:36:25 EDT
Sender: daemon@ucbvax.BERKELEY.EDU
Distribution: world
Organization: The ARPA Internet
Lines: 21

Hello to all on the network,

I have a question about setting up remote printers off of a decserver 200/mc.
I have successfully set up a remote printer port for a laser printer.  I want
to set up a port for a LA120.  The manuals give guidelines and examples
which i have followed, but nothing has helped.  What happens is that the
job is entered into the queue with the status "starting" and then after a
few seconds the queue stops and the job goes into a pending state.  I thought
it was possible that I set up the ports or the latcp protocol stuff wrong.
but i set up the same ports and latcp info on our decserver 100 and there
was no problem at all.  I suspect that because the decserver 200/mc
features modem control that I am not seeing something i should be aware of.

Has anyone else had this problem?  I would appreciate any info.  Please send
replies directly to my bitnet account.  Thanks,

Scott Marshall
systems manager
Trinity College, CT.
bitnet: trin7@trincc
------