Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!husc6!harvard!ksr!alcatraz!benson
From: benson@alcatraz.ksr.com (Benson Margulies)
Newsgroups: comp.protocols.appletalk
Subject: still can't get CAP4 to go.
Message-ID: <160@ksr.UUCP>
Date: Sun, 31-May-87 14:04:31 EDT
Article-I.D.: ksr.160
Posted: Sun May 31 14:04:31 1987
Date-Received: Tue, 2-Jun-87 02:48:23 EDT
Sender: nobody@ksr.UUCP
Reply-To: benson@ksr.UUCP ()
Distribution: world
Organization: Kendall Square Research, Cambridge MA
Lines: 39

With help from a cast of three or four, I got CAP4/KIP working to the
point where my Kinetics talks to the admin daemon, look works, and
nothing else does.

Heres my atalkatab


1.1	H      	192.9.200.200	KSR		#ksr ethernet
2.1	KC	192.9.200.200	KSR		#ksr appletalk net
	I192.9.200.0	L0			#ipbroad ipname
	L0	L0				#ildebug ipfile 
	L0 L0 L0 L0	S0 S0			#ipother unused unused
	LX0		S0	S10		#flags ipstatic ipdynamic
	S2.1	S1.1	"AT"    		#atneta atnete zonea


Here's the atalk.local for a typical node, ip address 192.9.200.17


# mynet mynode myzone 
1.1 17 AT
# bridgenet bridgenode bridgeIP
1.1 200 192.9.200.200

Note the use of the same net number for both MYNET and BRIDGENET

I picked this up from one of the people who has the stuff working.

This appears to be counter to the installation instructions, but
nothing works AT ALL if I actually list 2.1 in the atalk.local as the
bridge node. Also, KTALK/prompt claims that the node number of the
kinetics is 220, but here I have to call it 200.

Any help appreciated ...


Benson I. Margulies                         Kendall Square Research Corp.
harvard!ksr!benson			    All comments the responsibility
ksr!benson@harvard.harvard.edu		    of the author, if anyone.