Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watmath!clyde!rutgers!ames!sdcsvax!sdcc6!sdcc13!mu106sbn
From: mu106sbn@sdcc13.UUCP
Newsgroups: comp.sys.amiga
Subject: I'm trying to make a cable for a Maganavox 8CM515 monitor
Message-ID: <880@sdcc13.ucsd.EDU>
Date: Wed, 27-May-87 23:47:34 EDT
Article-I.D.: sdcc13.880
Posted: Wed May 27 23:47:34 1987
Date-Received: Fri, 29-May-87 04:40:41 EDT
Reply-To: mu106sbn@sdcc13.ucsd.edu.UUCP (Stephen Hartford)
Distribution: world
Organization: University of California, San Diego
Lines: 22
Keywords: Weird problems

I'm trying to get a Maganavox 8CM515 Analog RGB monitor to work with
an Amiga 1000. It appears to work fine, asking for Kickstart. But
after Kickstart loads, the screen goes black. The weird thing is
that if I boot all the way up using composite, it works fine. If
then, while in AmigaDOS, I plug the RGB cable in, presto! A perfect
RGB picutre. Can anybody help? I'm sure its soldered correctly...

Amiga pin #   Function     Maganavox 6-pin DIN #
------------------------------------------------
4             Green              1
11            H. sync            2
18            GND                3
3             Red                4
5             Blue               5
12            V. Sync            6


-- 
Stephen Hartford, programmer (a.k.a. student) 		      /// 
--							  \\\///
    Internet: mu106sbn%sdcc13@sdcsvax.ucsd.edu		   \///
	UUCP: ...!sdcsvax!sdcc13!mu106sbn