Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!mcnc!ecsvax!acs
From: acs@ecsvax.UUCP (Deanna Bowman)
Newsgroups: comp.sys.apple
Subject: disk II and IIGS
Message-ID: <3213@ecsvax.UUCP>
Date: Wed, 27-May-87 09:43:58 EDT
Article-I.D.: ecsvax.3213
Posted: Wed May 27 09:43:58 1987
Date-Received: Fri, 29-May-87 06:29:05 EDT
Distribution: na
Organization: UNC Educational Computing Service
Lines: 21


I have a GS with a disk II w/contoller plugged into slot 6.
I also have a 3.5" unidisk plugged into the smart port on the
back of the machine. My control panel is set to scan for a 
device to boot from. The problem:  when there is no disk in the
disk II the machine will not move on to the 3.5 and boot from
there. The disk II just keeps on spinning. Is there a way to 
make the GS continue scanning for a startup device when there is
no disk in the disk II? The local Apple dealer says it  is not
supposed work this way. It is interesting to note that I can go
into the control panel on boot and then immediately exit from
the control panel and this will work??!! The GS will attempt to
boot from the disk II and will continue scanning for a startup
disk/device if there is no disk in the disk II -- just like I 
want it to. Again the disk II is slot 6 drive 1 and the 3.5 disk
is slot 5 drive 1. If you have the 5.25" Unidisk daisy chained
to the 3.5" ( no disk II attached anywhere), things work fine just
like they say in the manual. Any ideas??
Wayne Fee -- Appalachian State U, Boone NC
 
> ... and you may ask yourself, How do I work this?... <