Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!rutgers!ucla-cs!sdcrdcf!trwrb!sansom
From: sansom@trwrb.UUCP (Richard Sansom)
Newsgroups: comp.sys.atari.st
Subject: GULAM: rx and sx - and help with GULAM & MWC 2.0
Message-ID: <1912@trwrb.UUCP>
Date: Thu, 21-May-87 11:14:40 EDT
Article-I.D.: trwrb.1912
Posted: Thu May 21 11:14:40 1987
Date-Received: Sat, 23-May-87 13:48:29 EDT
References: <436@sbcs.UUCP>
Reply-To: sansom@trwrb.UUCP (Richard Sansom)
Organization: TRW EDS, Redondo Beach, CA
Lines: 23

In article <436@sbcs.UUCP> pmt@sbcs.UUCP (Phil Tromovitch) writes:
> Did anyone manage to get the commands rx and sx to work?  In the manual,
>under 'sx', it says look at 'rx'.   But there's no entry for 'rx'  !!

You can rx a file by UNDOing te (after having started up the xmodem file
transfer on the other side) and typing: "rx file".  I haven't tried to sx a
file yet (sounds like fun ;-).  Once the transfer is complete, you may
resume your session by hitting the keypad "0".

Now, for my troubles:  I can't get the MWC 2.0 compiler to work correctly
with gulam.  I get errors about missing "}" characters in the pre-processor,
and all kinds of other strange stuff.

I _did_ set the env_type to mw, and that didn't seem to help too much (any).
Does anyone out there have any ideas?  Thanks.

-Rich

-- 
   /////////////////////////////////////\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
  /// Richard E. Sansom                   TRW Electronics & Defense Sector \\\
  \\\ {decvax,ucbvax,ihnp4}!trwrb!sansom  Redondo Beach, CA                ///
   \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\/////////////////////////////////////