Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watmath!clyde!rutgers!mit-eddie!genrad!decvax!ucbvax!THUMPER.BELLCORE.COM!mike
From: mike@THUMPER.BELLCORE.COM.UUCP
Newsgroups: comp.laser-printers
Subject: MacDraw PostScript included in ditroff documents?
Message-ID: <8706151453.AA10212@brillig.umd.edu>
Date: Thu, 4-Jun-87 18:51:35 EDT
Article-I.D.: brillig.8706151453.AA10212
Posted: Thu Jun  4 18:51:35 1987
Date-Received: Wed, 17-Jun-87 01:20:25 EDT
Sender: daemon@ucbvax.BERKELEY.EDU
Distribution: world
Organization: The ARPA Internet
Lines: 24
Approved: laser-lovers@brillig.umd.edu

Has anyone had any luck including PostScript as generated by MacDraw
into the middle of a ditroff document, using Transcript?  I tried the
following:

(1) capture the Postscript with command-F on the Mac
(2) prepend the LaserPrep file (as written by Brian Reid and stored on Sumex)
to the Mac output.
(3) use the ditroff sequence
        \!%PB
        <appropriate scaling commands>
        .cf <postscript file>
        \!PE
        \!.
as documented to insert the PostScript into the output stream.

Unfortunately, the LaserWriter blinks for a while and then nothing comes
out.  What am I doing wrong?

If I just send the PostScript file straight to the printer, without the
surrounding ditroff, it works fine.

        Mike Caplinger
        mike@bellcore.com
        {decvax,ihnp4}!thumper!mike