Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watmath!clyde!ima!think!whitney
From: whitney@think.UUCP
Newsgroups: comp.sys.apple
Subject: Re: RE:gs modem port fix
Message-ID: <5017@think.UUCP>
Date: Thu, 4-Jun-87 16:47:52 EDT
Article-I.D.: think.5017
Posted: Thu Jun  4 16:47:52 1987
Date-Received: Sat, 6-Jun-87 09:35:51 EDT
References: <8706020746.AA13305@crash.CTS.COM>
Sender: news@think.UUCP
Reply-To: whitney@godot.think.com.UUCP (David Whitney)
Distribution: world
Organization: Thinking Machines Corporation, Cambridge, MA
Lines: 34

In article <8706020746.AA13305@crash.CTS.COM> hp-sdd!pnet01!pro-sol!mdavis@AMSAA.arpa writes:
>You can change the baud rate, as was stated earlier, on a IIGS by typing:
>
>        ]IN#2
>        <ctrl-A><T>                             <-- terminal mode
>        <cktl-A><6><B>                          <-- set 1200 bps (10B is 2400)
>        ....                                    <-- do whatever you need to
>        <ctrl-A><Q>                             <-- quit terminal mode
>        ]IN#0
>
>This works.
>
>UUCP: [ ihnp4 akgua hplabs!hp-sdd sdcsvax nosc ] !crash!pnet01!pro-sol!mdavis
>ARPA: crash!pnet01!pro-sol!mdavis@nosc
>INET: mdavis@pro-sol.CTS.COM

Um, as I remember the Super Serial Card manual, <6><B> sets 300 baud.
<8><b> sets 1200 baud. Now I tried this (have you TRIED it?), and it
causes the system to hang up when I try to type to the modem. I do
exactly this:

IN#2
<ctrl-A>T
AT
  --> modem goes "OK"
<ctrl-A>8B
A  --> no more cursor. couldn't even hit 'T' or RETURN.

I have a "Woz" special. Were any bugs identified in these early models?
If so, how can I have them fixed??

		Dave Whitney
		...!ihnp4!think!whitney
		whitney@think.com