Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!mcnc!ece-csc!ncrcae!ncr-sd!hp-sdd!ucsdhub!sdcsvax!ucbvax!wnre.aecl.CDN!delaney
From: delaney@wnre.aecl.CDN (Grant Delaney)
Newsgroups: comp.sys.apple
Subject: Decom speed
Message-ID: <827*delaney@wnre.aecl.cdn>
Date: Thu, 18-Jun-87 22:30:54 EDT
Article-I.D.: wnre.827*delaney
Posted: Thu Jun 18 22:30:54 1987
Date-Received: Mon, 22-Jun-87 01:23:19 EDT
Sender: daemon@ucbvax.BERKELEY.EDU
Distribution: world
Organization: The ARPA Internet
Lines: 8

John I sort of ran into the same problem when I forgot to change the default
baud rate on my modem port of my GS.  Decom can not set the baud rate it
uses the default set on you serial interface.  Two solutions:
1. reset you serial interface to the desired baudrate
2. exit decom and use ctrAxB to set the right baud rate
  after an IN#2 if your inter face follows super serial 
  proticol
Grant Delaney