Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!uwvax!vanvleck!uwmcsd1!csd4.milw.wisc.edu!dpeter
From: dpeter@csd4.milw.wisc.edu (Peter J Diaz de Leon)
Newsgroups: comp.sys.ibm.pc
Subject: CONFIG.SYS
Message-ID: <2362@uwmcsd1.UUCP>
Date: Sat, 27-Jun-87 15:08:38 EDT
Article-I.D.: uwmcsd1.2362
Posted: Sat Jun 27 15:08:38 1987
Date-Received: Sun, 28-Jun-87 02:01:38 EDT
Sender: daemon@uwmcsd1.UUCP
Reply-To: dpeter@csd4.milw.wisc.edu (Peter J Diaz de Leon)
Distribution: na
Organization: University  of Wisconsin-Milwaukee
Lines: 20

I have created a config.sys file on my system, and one of the commands in it is
SET LISP%LIB=C:\UTIL

However when I issue the SET command at the C> prompt is shows me 
LISPLIB=C:\UTIL

Where did the % go.

But if I issue SET LISP%LIB=C:\UTIL at the C> prompt it works fine.

I am running MSDOS 3.1 on a COMPAQ DESKPRO 286 two floppies and a 1.5MB
Ram Drive.

			thanks in advance
			peter

==============================================================================
ARPA: dpeter@csd4.milw.wisc.edu
      peter@uwm-cs.milw.wisc.edu
==============================================================================