Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!seismo!rutgers!aramis.rutgers.edu!mende
From: mende@aramis.rutgers.edu (Bob Mende)
Newsgroups: comp.sys.amiga
Subject: hardware parameters needed for SLIP
Message-ID: <970@aramis.rutgers.edu>
Date: Mon, 6-Jul-87 13:40:49 EDT
Article-I.D.: aramis.970
Posted: Mon Jul  6 13:40:49 1987
Date-Received: Tue, 7-Jul-87 05:41:37 EDT
Organization: Rutgers Univ., New Brunswick, N.J.
Lines: 22
Keywords: SLIP IP network


Hi ...

   I am in the process of running SLIP (Serial Line IP) on my amiga.
I need two pieces of information that I dont have (since I dont have
the RKM or hardware manual.)

   1.	<I/O address>.  The base address of the control registers of
			the serial device.

   2.	<vector>.	The interrupt vector number of the serial
			device. 

   If you have then ... Please specify if they are in decimal or hex.
			


				Thanks...

					Bob
-- 
     mende@rutgers.edu    {...}!rutgers!mende    mende@zodiac.bitnet