Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!seismo!rutgers!ames!schoch
From: schoch@ames.arpa (Steve Schoch)
Newsgroups: comp.dcom.modems
Subject: Re: Synchronous 9600bps Smart Modems?
Message-ID: <2464@ames.arpa>
Date: Sun, 9-Aug-87 01:16:01 EDT
Article-I.D.: ames.2464
Posted: Sun Aug  9 01:16:01 1987
Date-Received: Sun, 9-Aug-87 13:22:55 EDT
References: <55@oresoft.UUCP>
Distribution: na
Organization: NASA Ames Research Center, Moffett Field, Calif.
Lines: 16

In article <55@oresoft.UUCP> randy@oresoft.UUCP (Randy Bush) writes:
>Yes, it would be wonderful if the HST (and Telebit) would revert to the EEROM
>settings when the call is finished.  Note that the Telebit reverts to *factory*
>(not EEROM) settings if an outbound call collides with an inbound call.  This
>is usually very confusing to the software.

We have a new Telebit TrailBlazer on ames and have it set to revert to the
EEROM whenever DTR drops.  As DTR should drop after every call (if it's an
incoming call, the DTR will drop when uucico exits, and go high again when
a new getty starts; if it's an outgoing call, uucico should drop DTR when
it's done -- if not, it's broken) we have no problems with default settings.

Having an incoming call collide with an outgoing call is always confusing.
The other side is expecting login and we're sending ATDT....

	Steve