Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!mit-eddie!jbs
From: jbs@eddie.MIT.EDU (Jeff Siegal)
Newsgroups: comp.mail.uucp,comp.dcom.modems,comp.unix.wizards
Subject: 4.3 UUCP Hayes dialer
Message-ID: <6895@eddie.MIT.EDU>
Date: Wed, 16-Sep-87 13:27:49 EDT
Article-I.D.: eddie.6895
Posted: Wed Sep 16 13:27:49 1987
Date-Received: Sat, 19-Sep-87 01:12:18 EDT
Reply-To: jbs@eddie.MIT.EDU (Jeff Siegal)
Organization: MIT, EE/CS Computer Facilities, Cambridge, MA
Lines: 13
Xref: mnetor comp.mail.uucp:831 comp.dcom.modems:955 comp.unix.wizards:4276

I am attempting to set up UUCP to dial out using Racal-Vadic VA2400VP
(Maxwell) modems.  Attempting to use the Hayes dialer (hys.c) fails in
a rather strange way: The modem replies "OK" to the initial setup
command, but the expect("OK\r", hd) call fails (does not find the
"OK").  I thought that the modem might be sending a linefeed before
the CR, so I took out the \r from the expect call, but that didn't
help.

This is with post-4.3-release UUCP obtained from seismo a while back.

Any ideas/suggestions/guesses?

Jeff Siegal