Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!mnetor!uunet!seismo!rutgers!ucla-cs!zen!ucbvax!YALE.ARPA!LEICHTER-JERRY From: LEICHTER-JERRY@YALE.ARPA Newsgroups: comp.laser-printers Subject: re: LN03 font CG TIMES font width information Message-ID: <8708102301.AA12200@brillig.umd.edu> Date: Sat, 29-Aug-87 21:58:15 EDT Article-I.D.: brillig.8708102301.AA12200 Posted: Sat Aug 29 21:58:15 1987 Date-Received: Sun, 30-Aug-87 10:14:15 EDT Sender: daemon@ucbvax.BERKELEY.EDU Reply-To: Organization: The ARPA Internet Lines: 27 Approved: laser-lovers@brillig.umd.edu Our installation has two LN03 PLUS printers connected to our VAX. We have recently aquired one of the DEC font cartridges for the CG TIMES (RTIMES0) font set..... What we would like to do is use the font in connection with TeX and WordPerfect. Both of these require that we get accurate font metric information for the individual character glyphs. This information did not come with the font cartridge. Does anyone know where we can get this information? ... The "real man's" way to get this information is to measure it by hand. Tedious and error-prone - not a good idea, except perhaps from mono-spaced fonts. The best way is to go to the source of the fonts, CompuGraphic Corp. They sell this information - ask about "Product 621", which is a width table of any fonts you would like. Available both in hardcopy and on magtape. I have no idea what it costs. (I'd be very surprised in no one has done this yet for both TeX and WordPerfect; you just have to FIND them.) A compromise (cheaper, still tedious - but better than measuring by hand!) is to let the printer itself do the measuring for you: The LN03 can report back to the host its current active position. To get the report, enter Sixel mode at 300dpi (SSU command) and use DSR (Device Status Request) to ask for the position. (Details omitted - see the documentation.) -- Jerry -------